DriSteem Vapor-Logic Instalační příručka Strana 61

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 80
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 60
DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual Page 59
• Remove loose deposits and residue that falls into rear header with
a vacuum cleaner and hose extension.
• Inspect 1½" (DN40) return tubes and clean if necessary.
• Run thin brush between turbulator and tube wall on all four
sides.
• Reinstall burner assemblies and gaskets; vent box and
gasket; all electrical wiring; gas train shroud; and pressure switch
connections.
Burner maintenance
Under normal use conditions, the burner(s) should not need
cleaning for a minimum of five years. However, depending on
the operating environment, the burner(s) may require periodic
cleaning to remove accumulated materials. Failure to clean burners
can result in reduced unit capacity. Use sealed combustion in dirty
environments. See burner maintenance instructions below.
Burner maintenance instructions
To service the burner system, clean both the blower and the burner.
Remove the blower(s) from the system and clean dust from the
wheel. Remove the burner(s) for cleaning. Removing and cleaning
one burner at a time eases reassembly. To dislodge particulate
matter from the burner surface matrix, use compressed air
(100 psig [700 kPa] maximum). Keep the air nozzle about 2"
(50 mm) from the burner’s surface, blowing air perpendicular
to the burner surface while moving the nozzle back and forth
lengthwise. This dislodges particles trapped in the matrix, pushing
them back inside the burner. Avoid blowing air across the surface,
which tends to have a destructive effect on the burner surface.
Allow particulate matter to fall from the burner through the air/gas
inlet. To assist in removing the particulate matter, use a vacuum at
the burner’s air/gas inlet.
Replacement parts
When servicing or repairing this equipment, use only DRI-STEEM
approved service replacement parts. Complete replacement part
lists are on Pages 69-75. Refer to the rating plate on the unit for
complete unit model number, serial number, and company address.
Any substitution of parts or controls not approved by DRI-STEEM
will be at owner’s risk and will void the warranty.
Note:
Soot and carbon deposits may indicate
a combustion problem that needs to be
corrected. Consult the factory.
M a i n t e n a n c e : G T S a n d G T S - D I
m o d e l s ( c o n t i n u e d )
W A R N I N G !
When cleaning burners with compressed
air, wear appropriate respiratory protection.
Failure to do so may cause severe bodily
injury.
mc_052708_1610
Maintenance
Zobrazit stránku 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 79 80

Komentáře k této Příručce

Žádné komentáře